Fujitsu PRIMEQUEST 500A Series Installation Manual page 313

8 Reboot the system.
The settings are validated after the system reboot.
4.10.1.3 Verifying the memory dump settings
Perform a memory dump in advance to make sure that memory information is
dumped normally. In addition, measure the time taken until dump is output actually
and the time taken for a system restart in order to estimate the time required till
business can be restarted. Based on that result, reconsider the dump mode as needed.
To implement a dump, specify INIT for the target partition by selecting [Partition] -
[Power Control] from the MMB Web-UI. For details, see Chapter 5, "MMB Web-
UI," in the PRIMEQUEST 580A/540A/520A/500/400 Series Reference Manual: Basic
Operation/GUI/Commands (C122-E003EN).
4.10.1.4 Setting the paging file
Set the paging file by following the procedure below. Unless otherwise instructed,
use the values that are automatically assigned during Windows installation for the
paging file.
1 Log on to the server with the administrator privilege.
2
Click [Start]
The [System Property] dialog box appears.
3
Click the [Detail Setting] tab, and click [Set] at [Performance Options].
The [Performance Options] dialog box appears.
C122-E001-10EN
4.10 Setting Up the Dump Environment (Windows Server 2003)
→ →
[Control Panel] [System].
4-127