Table of Contents
Advertisement
3
Enter the ps command to check whether snmpd is active.
Command syntax:
ps ax | grep snmpd
Example: snmpd is active if /usr/sbin/snmpd is displayed.
# ps ax | grep snmpd
32611 ?
snmpd -a
4
If snmpd is active, enter the service command to stop snmpd.
Command syntax:
/sbin/service snmpd stop
5
Change the value of oldEngineID defined in the /var/net-snmp/snmpd.conf file.
Remarks: You can change to any value in up to 34 hexadecimal digits, provided that it
Example: To change the value of oldEngineID to 0x19760523
#vi /var/net-snmp/snmpd.conf
oldEngineID 0x19760523
6
Enter the service command to start snmpd.
Command syntax:
/sbin/service snmpd start
7
Change the current directory to /opt/FJSVpsa/sh/ to regenerate the snmpv3
password used for the PSA internal communication.
Command syntax:
cd /opt/FJSVpsa/sh/
C122-E001-10EN
4.2 PSA Installation (Linux: Red Hat) (PRIMEQUEST 580A/540A/580/540/480/440)
S
0:04 /usr/sbin/snmpd -Lsd -Lf /dev/null -p /var/run/
is unique throughout the partitions in the same cabinet.
4-19
Advertisement
Chapters
Table of Contents
