Fujitsu PRIMEQUEST 500A Series Installation Manual page 245

-A authPassword: Specifies an authentication password (eight or more characters).
-x privProtocol:
-X privPassword: Specifies an encryption password (eight or more characters). The
Example: When you want to send SNMPv3 traps with the "PRIMEQUEST" account,
#trapsess 3 -e 0x800007e58026577a9f421950a4 -u PRIMEQUEST -l authPriv
-a MD5 -A 00000000
-x DES -X 11111111 192.168.1.10:162
After setting the trap transfer destination, restart snmpd by executing the following
command:
#/etc/init.d/snmpd restart
After snmpd has been reactivated, activate PSA.
#/etc/init.d/y30FJSVpsa y30FJSVpsa stop
#/etc/init.d/y30FJSVpsa y30FJSVpsa start
C122-E001-10EN
4.4 PSA Installation (Linux: SUSE) (PRIMEQUEST 500A/500/400 series common)
The password must be the same as the setting in the manager.
This option is valid when authentication is included in the security
level specified by the -l option. It can be omitted if the
authentication is not included.
Specifies the protocol used to encrypt SNMPv3 messages.
Currently, only DES is supported as a privacy protocol. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
password must be the same as the setting in the manager. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
with authentication and encryption enabled, to port 162 of the manager
with IP address 192.168.1.10
##SNMPv3 trap setting
4-59