Fujitsu PRIMEQUEST 500A Series Installation Manual page 255

4.5.1 Checking the management LAN settings
This section describes how to check the management LAN settings.
For communication of PSA with the MMB via the management LAN, the NIC
connected to the management LAN on the partition side must be active.
Note:
(1) Verifying the NIC for the management LAN
In Device Manager, display the properties of the network adapters (Intel PRO/100 VE
Network Connection and Intel PRO/100 M Network Connection) assigned to the
management LAN, and check the settings in [Location] on the [General] tab.
Connect the network adapters for the management LAN to MMB#0 and MMB#1 as
follows:
- MMB#0: PCI Bus 1, Device 8, Function 0
- MMB#1: PCI Bus 1, Device 0, Function 0
Use the teaming function of Intel PROSet to configure the above network adapters for
duplicated communication with the management LAN.
For Intel PROSet teaming, specify the IP addresses of the devices for the management
LAN that are configured for duplicated communication.
(2) Configuring the two network adapters for the management LAN so that
the adapters are duplicated
Use the teaming function of Intel PROSet to configure the network adapter for the
management LAN to guarantee management LAN operation for duplicated
communication.
Install Intel PROSet beforehand.
Note:
C122-E001-10EN
4.5 PSA Installation (Windows Server 2003) (PRIMEQUEST 580A/540A/580/540/480/440)
If you perform batch installation using the batch installer included in the
High-Reliability Tools, configure the management LAN after the batch
installation is completed.
Change the VLAN setting of the MMB management LAN hub to "VLAN
Mode." (For details, see
The Spanning Tree Protocol (STP) function of the switch connected to the
user port (management LAN) of the MMB must be disabled.
To make settings through a connection to a remote desktop, a console
session connection must be established. Establish this type of connection
according to the following procedure:
2.2.4.5, Setting a management LAN hub.)
4-69