Fujitsu PRIMEQUEST 500A Series Installation Manual page 328

CHAPTER 4 Work Required After Operating System Installation
(2) Check the disk configuration.
1
Check the mount status.
# cat /etc/fstab
2
Record the partition configuration information.
In cases such as a disk failure, restoration on a new disk may be necessary.
Accordingly, the parted command must be used to record the current partition
configuration and prepare for restoration.
See below for an example of recorded information.
Example:
# parted
(parted) unit s
(parted) print
Disk /dev/sdb: 71390319s
Sector size (logical/physical): 512B/512B
Partition table: gpt
No.
1
2
3
4
(parted) quit
Remarks:In RHEL5 (IPF), the print subcommand of the parted command displays
3
Check file system label names.
# e2label /dev/sda2
* If a device mounted in /boot/efi is specified, an error occurs. This error occurs
because the file system is different. That does not cause a problem because
"boot/efi" is not defined as a label name, checking it is not required.
4-142
Start End
34s 204833s
204834s 42147873s
42147874s 46228383s
46228384s 67199903s
simplified values with units such as "MB" added to the values. Therefore,
the values may differ greatly from the actual sizes.
To minimize differences from the size displayed at the backup time, change
the display unit to a smaller measurement unit before executing the print
subcommand, and record it for partition reconfiguration.
In the above example, "unit s" is used for the display unit (s) for sectors.
Size File system
204800s fat16
41943040s ext2
4080510s linux-swap
20971520s ext2
Name Flag
Primary
msftres
Primary
Primary
Primary
C122-E001-10EN