Fujitsu PRIMEQUEST 500A Series Installation Manual page 231

To make the management LAN NIC settings effective, PSA need to be restarted.
Command syntax:
/etc/init.d/y30FJSVpsa stop
/etc/init.d/y30FJSVpsa start
• Using PRIMECLUSTER GLS
For the settings to duplicate the management LAN using PRIMECLUSTER GLS,
see the PRIMECLUSTER GLS manual. To use PRIMECLUSTER GLS, specify
the external switches connected to the MMB user ports shown in
Figure 4.4
Note: If a network has already been configured for the management LAN, use
After configuring the duplication settings by the GLS, restart the network service
and then restart the PSA.
Command syntax:
/etc/init.d/y30FJSVpsa stop
/etc/init.d/y30FJSVpsa start
• SUSE 10
1 Add the line shown below to the end of /etc/modprobe.conf.local.
Name the Bonding interface (bondN, where N is a number assigned in ascending
order, such as 0, 1, 2...).
# vi /etc/modprobe.conf.local
Add the following line to the end of the file:
alias <Bonding interface-name> bonding
options <Bonding interface-name> mode=1 arp_interval=1000
arp_ip_target=<external-switch-IP-address>// (*1)
*1 For the configuration shown in
configuration shown in
options <Bonding interface-name> arp_ip_target=<external-switch-IP-
address(1)>,<external-switch-IP-address(2)>
C122-E001-10EN
4.4 PSA Installation (Linux: SUSE) (PRIMEQUEST 500A/500/400 series common)
as the monitored hubs.
the IP address specified in the ifcfg file as the IP address for
PRIMECLUSTER GLS and configure the duplication settings by
following the instructions in the PRIMECLUSTER GLS manuals.
Figure
Figure 4.5, specify one IP address. For the
4.6, specify two IP addresses.
Figure 4.3 and
4-45