Fujitsu PRIMEQUEST 500A Series Installation Manual page 431

PRIMEQUEST 520A/520/420
IOU
BMM#0
IP =
192.168.1.1
MMB
IP =
192.168.1.100
REMOTE REMOTE
For remote
maintenance
IP =
Dial-up router or
192.168.3.202
external switch
REMCS center
Figure F.2 Management LAN network configuration and IP addresses
The main applications of IP addresses are described below.
• MMB IP addresses
MMB has one IP address for management and a virtual IP address for REMOTE
MAINTENANCE.
The IP address for management is used as the SNMP access destinations from the
management server or the MMB Web-UI operation. PSA Web-UI operation is also
performed via the MMB Web-UI.
Note:
C122-E001-10EN
BMM#1
REMCS VIP =
192.168.3.102
For local For management
maintenance
by the user
External switch
Maintenance terminal (FST)
IP =
IP =
192.168.1.200
192.168.1.201
(PRIMEQUEST 520A/520/420)
If you want to use a switching hub that supports a loop guard function
(such as the spanning tree protocol and domain separation) as an
external switch, suppress the loop guard function by disabling
[Spanning Tree Protocol] for the port for connection between the
switching hub and the main unit or by turning on [Domain Separation].
Appendix F Overall View of Management LAN IP Addresses
IOX
BMM#1
BMM#0
IP =
192.168.1.8
Notes:
1. The IP addresses in this figure are examples.
2. IP: Physical address
REMCS IP: IP adress for remote maintenance.
3. Two subnets must be setup: One for management by
the user, the other for remote maintenance.
Web-UI Web-UI
Specify the same subnet for management by the user
and for local maintenance.
4. BMM#1 is supported only in the PRIMEQUEST 520A/520.
F-3