Fujitsu PRIMEQUEST 500A Series Installation Manual page 326

CHAPTER 4 Work Required After Operating System Installation
4.12 OS Backup Settings
This section describes how to back up Linux (Red Hat) or Windows. For information
on restoration, see Chapter 1, "System Maintenance" in the PRIMEQUEST 500A/500/
400 Series Reference Manual: Tools/Operation Information (C122-E074EN).
Linux (Red Hat) backup
Windows backup
4.12.1 Linux (Red Hat) backup
This section describes how to back up system volumes contained in a partition in
which the Linux OS is installed. Two Linux backup methods are available:
Using the standard OS utilities
Using SystemcastWizard Lite
The Linux OS system volume backup procedure as described below uses the standard
OS utilities in each of the following two cases:
• When PRIMECLUSTER GDS is not used
• When PRIMECLUSTER GDS is used
Note:
Remarks:Perform the backup/restoration operation from the OS console. A KVM
For details on use of SystemcastWizard Lite for Linux backup, see the PRIMEQUEST
SystemcastWizard Lite User's Guide (C122-E010EN).
4-140
(→ 4.12.1)
(→ 4.12.2)
Prepare a single unit such as a tape unit as a backup device.
console or serial console can be used.
C122-E001-10EN