Fujitsu PRIMEQUEST 500A Series Installation Manual page 250

CHAPTER 4 Work Required After Operating System Installation
8 Execute snmpsetup.sh in the above directory.
Executing this command automatically generates the snmpv3 password used for
the PSA internal communication.
Command syntax:
./snmpsetup.sh install
9
Start PSA.
Command syntax:
/etc/init.d/y30FJSVpsa start
4.4.8 PSA update installation
Using the following commands in the order shown, stop the PSA service, and perform
update installation for the PSA package.
Note:
Command syntax:
Update from PSA-1.2.X-X or later
/etc/init.d/y30FJSVpsa stop
/bin/rpm -Uvh FJSVpsa-X.X.X-X.ia64.rpm
/etc/init.d/y30FJSVpsa start
Update from PSA-1.1.X-X
/etc/init.d/y30FJSVpsa stop
/bin/rpm -Uvh FJSVpsa-X.X.X-X.ia64.rpm
/etc/init.d/y10FJSVpsa start
/etc/init.d/y30FJSVpsa start
* X.X.X-X indicates the PSA version.
4-64
If the PEXU has been mounted, use PSA-1.10 or later.
C122-E001-10EN