Fujitsu PRIMEQUEST 500A Series Installation Manual page 189

4.2 PSA Installation (Linux: Red Hat) (PRIMEQUEST
580A/540A/580/540/480/440)
This section describes the items that must be checked before PSA installation.
Required tasks:
Checking the management LAN settings
Checking the SELinux function settings
Checking the firewall function (releasing ports)
Installing FJSVfefpcl
Optional tasks:
Setting the destination of trap sending from the partition
Setting the destinations of trap and e-mail sending via the MMB
Other settings
Remarks:
C122-E001-10EN
4.2 PSA Installation (Linux: Red Hat) (PRIMEQUEST 580A/540A/580/540/480/440)
(→ 4.2.4)
(→ 4.2.7)
Use the PRIMEQUEST installation support tool, bundled-software
package installer, or SystemcastWizard Lite to install PSA. If you want to
manually install PSA, see Chapter 4, "Manual PSA Installation" in the
PRIMEQUEST 500A/500/400 Series Reference Manual: Tools/Operation
Information (C122-E074EN).
For details on the installation support tool, see the PRIMEQUEST
Installation Support Tool User's Guide (Red Hat) (C122-E005EN).
For details on the bundled-software package installer, see the
PRIMEQUEST Bundled-Software Package Installer User's Guide (C122-
E006EN).
For details on SystemcastWizard, see the PRIMEQUEST
SystemcastWizard Lite User's Guide (C122-E010EN).
During PSA installation, the following modifications required for PSA
operation are automatically put into effect:
- Adding of settings to syslog.conf
- Adding of settings to snmpd.conf
- snmptrapd.conf file setup
- Disabling of salinfo or salinfo_decode automatic startup setting (*1)
- Disabling of smartd automatic startup setting
(→ 4.2.1)
(→ 4.2.2)
(→ 4.2.3)
(→ 4.2.5)
(→ 4.2.6)
4-3