Fujitsu PRIMEQUEST 500A Series Installation Manual page 62

CHAPTER 2 Setup
2.2.3 Network settings for actual operation
This section explains the following settings, which are required for actual operation.
Perform these as needed for your operation mode.
Setting up the MMB network (PRIMEQUEST 580A/540A/580/540/480/440)
2.2.3.1)
Setting up the MMB network (PRIMEQUEST 520A/520/420)
Specifying Telnet parameters
Setting up the DNS server
For backing up the settings, see
Remarks: This can be performed by users with administrator privilege.
2.2.3.1 Setting up the MMB network (PRIMEQUEST 580A/540A/580/
540/480/440)
Specify information including the virtual IP address used to access the Web-UI and
the physical IP address assigned to the MMB interface.
Note that this information may have already been set by a Fujitsu certified service
engineer. If the information need not be changed, proceed with the next setting.
Notes:
Remarks:
2-16
(
→
(
Section 2.6, "Saving Configuration Information."
Specify the same subnet for the physical and virtual IP addresses of
MMB#0 and MMB#1.
When the virtual IP address is set, and the PRIMEQUEST series machine
is accessed from an external device (for example, from a
Web browser, maintenance terminal, the REMCS, etc.), the access is
performed through the virtual IP address. Therefore, it is impossible to
access the MMB Web-UI by specifying the physical IP address of MMB
#0 or MMB #1.
If you make changes to [MMB#0 IP Address] or [MMB#1 IP Address]
and click the [Apply] button in the [Network Interface] window, the
network is temporarily stopped and the Web-UI is disconnected to reflect
the settings. In this case, you can reconnect the Web-UI by making a
selection from the menu.
When the IP address is changed, the connection to the MMB Web-UI is
terminated. To use the MMB Web-UI, log in again.
→
2.2.3.3)
2.2.3.4)
→
(
→
( 2.2.3.2)
C122-E001-10EN