Fujitsu PRIMEQUEST 500A Series Installation Manual page 248

CHAPTER 4 Work Required After Operating System Installation
4.4.7 Other settings
Remarks:Make this setting only if required.
Setting required when a replicated disk is used
You can build a new partition by using a disk copied from a partition in the same
cabinet, such as disk copy. In this case, you need to manually change the EngineID
of SNMPv3 used for the PSA internal communication.
You can change the EngineID with root authority as follows:
1 Use the ps command to check whether PSA is active.
Command syntax:
ps ax | grep psa
Example: PSA is active if the following processes under /opt/FJSVpsa/bin/ are
# ps ax | grep psa
4562 ?
global/pmpsa.conf
4563 ?
4564 ?
4565 ?
4566 ?
4567 ?
4568 ?
4569 ?
4570 ?
4578 ?
4819 ?
21670 pts/5
2
If PSA is active, use the following command to stop PSA.
Command syntax:
/etc/init.d/y30FJSVpsa stop
4-62
displayed.
S 0:00 /opt/FJSVpsa/bin/pm -o 70 /etc/opt/FJSVpsa/
S 0:18 /opt/FJSVpsa/bin/loggetd -p /
S 0:06 /opt/FJSVpsa/bin/sisp -p /
S 0:00 /opt/FJSVpsa/bin/mmbm -p /
S 0:01 /opt/FJSVpsa/bin/mmbs -p /
S 0:02 /opt/FJSVpsa/bin/fs -p /
S 0:00 /opt/FJSVpsa/bin/ciipmi -p /
S 7:40 /opt/FJSVpsa/bin/cilog -p /
S 8:47 /opt/FJSVpsa/bin/cios -p /
S 0:00 /opt/FJSVpsa/bin/cisalchild 1 /
Sl 0:00 /opt/FJSVpsa/bin/webgate -p /
S+ 0:00 grep psa
C122-E001-10EN