Figure 2.12 [Alarm E-Mail] Window; Table 2.8 Displayed And Setting Items In The [Alarm E-Mail] Window - Fujitsu PRIMEQUEST 500A Series Installation Manual

Setting e-mail reporting
• Procedure
1 Click [Network Configuration]
The [Alarm E-Mail] window is displayed.
2
Specify the required items.

Table 2.8 Displayed and setting items in the [Alarm E-mail] window

Alarm E-Mail
From:
To:
SMTP Server
Subject
3 Click the appropriate button.
• To set e-mail sending conditions: Click the [Filter] button.
• To enable the setting: Click the [Apply] button.
• To send e-mail for testing: Click the [Test
Note:
C122-E001-10EN

Figure 2.12 [Alarm E-Mail] window

Item
Specifies whether to transmit an Alarm E-Mail if an event
occurs. To specify transmission, select [Enable].
Sets the E-Mail address of the sender.
Sets the E-Mail address of the recipient.
Sets an SMTP server IP address or FQDN. Note that the
FQDN can be set only when a DNS has been set.
Sets the subject of the mail.
A DNS server must be specified prior to specifying a fully qualified
domain name (FQDN). You can specify it by selecting [Network
→
Configuration] [Network Interface].
→
[Alarm E-Mail].
Description
E-Mail
2.2 MMB Connection and Setup
] button.
2-23