Fujitsu PRIMEQUEST 500A Series Installation Manual page 236

CHAPTER 4 Work Required After Operating System Installation
4.4.2 Procedures for monitoring syslog
When using SUSE™ Linux Enterprise Server 10, you must make the addition settings
below.
Note:
Remarks: Use the [ ↑ ] and [ ↓ ] keys to move the cursor up and down on the YaST
1
Enter the following command to confirm the active syslog daemon.
# grep SYSLOG_DAEMON /etc/sysconfig/syslog
If SYSLOG_DAEMON = If "syslog-ng" is displayed for SYSLOG_DAEMON,
If SYSLOG_DAEMON = If "syslog" is displayed for SYSLOG_DAEMON,
Record the name of the running syslog daemon.
2 Change the AppArmor settings by following the procedure below:
1 Start YaST.
# yast
4-50
If you fail to make the settings below before installing PSA, the following
message may be output when you install PSA and PSA may not be able to
monitor driver messages.
syslogd: /var/opt/FJSVpsa/path/syslogd.fifo: Operation not permitted
screen.
/sbin/syslog-ng is running as the syslog daemon.
/sbin/syslogd is running as the syslog daemon.
Figure 4.8 YaST start screen
C122-E001-10EN