Fujitsu PRIMEQUEST 500A Series Installation Manual page 253

4 SNMP security setting
5
Window Management Instrumentation (WMI) setting
6 Task scheduler settings
C122-E001-10EN
4.5 PSA Installation (Windows Server 2003) (PRIMEQUEST 580A/540A/580/540/480/440)
Make SNMP Service security settings because PSA must receive
SNMP packets from the MMB.
The subsequent operations varies as follows depending on the
parameter selected on the [Security tab] in the [Properties] dialog box
of [SNMP Service] during PSA installation:
• If [Accept SNMP packets from any host] was selected:
The SNMP security settings need not be made.
• If [Accept SNMP packets from these hosts] was selected:
Make sure SNMP security settings unless the IP address of the MMB
and localhost parameter are not specified.
Note:To change the SNMP Service security setting from [Accept
SNMP packets from any host] to [Accept SNMP packets from
these hosts] after PSA installation, or to change the IP address
of the MMB, execute the SNMP security setting command
(setsnmpsec). For details on this command, see the
PRIMEQUEST 580A/540A/520A/500/400 Series Reference
Manual: Basic Operation/GUI/Commands (C122-E003EN).
PSA collects information on PCI cards and SCSI devices by using
WMI, which is installed as standard with Windows.
If the amount of memory and the number of internal handles that WMI
uses to collect this information are insufficient because there are many
LUNs, such as in RAIDs, change settings to the following values:
• Maximum amount of memory used: 536,870,912 bytes
• Maximum number of internal handles: 65,536
To monitor for errors involving the power supply of the expansion file
unit and FANs, make the following task scheduler settings:
Task name: File Unit Status Check
Activation interval: 5 minutes
The configuration information is collected when the PSA is started.
Error monitoring is then performed based on the collected information
until the next time the PSA is started. If an expansion file unit is not
connected, configuration information is collected according to the
schedule, but the process is completed immediately without error
monitoring performed. Therefore, no additional workload is imposed
on the system.
4-67