Fujitsu PRIMEQUEST 500A Series Installation Manual page 141

3.2.3.2 Connecting the devices
Perform the following steps to connect the devices:
(1) Connecting a deployment server
1
Connect to the network the deployment server.
To install SystemcastWizard Lite, see the PRIMEQUEST SystemcastWizard Lite
User's Guide (C122-E010EN).
Figure 3.10 Example of connections for installation using SystemcastWizard Lite
Notes:
C122-E001-10EN
PRIMEQUEST
Deployment
MMB
server (A)
MMB console (B)
Management LAN
Although the PXE function is used to activate the network, you cannot
activate the network across a router. Therefore, connect the deployment
server to the management LAN to which the PRIMEQUEST machine is
connected.
The target partition is started remotely or MMB#0 is used for all
communication for backup or restoration. Always perform this operation
with MMB#0 connected to the management LAN. However, MMB#0
need not be active.
Partition
Partition
Partition
Remarks:
If the deployment server (A in the figure) can run the
Web browser, the deployment server can be used as the
MMB console. In such case, you do not need to obtain
a separate MMB console (B in the figure).
3.2 Linux Installation
3-19