Fujitsu PRIMEQUEST 500A Series Installation Manual page 406

Appendix D Installation in the SAN Boot Environment
18 Press the [Esc] key five times. The system returns to the state at EFI shell startup.
Drv[22]
None
Shell>
19 Apply the settings.
Reset the partition. From the [Power Control] window, select the [Reset] from
[Power Control] pull-down menu of the partition to be reset, and click the [Apply]
button. Otherwise, enter the reset command.
Shell> reset
Remarks: For details, see Emulex Corporation's EFIBoot Web site.
D.4.4.2 Configuring the EFI driver (3.11a4 version/3.11x1 version)
1
Turn on power to the partition.
The [EFI Boot Manager] window is displayed on the console.
EFI Boot Manager ver x.xx [x.xx]
Please select a boot option
EFI Shell [Built-in]
DVD/Acpi(PNP0A03,0)/Pci(1D|1)/Usb(0, 0)/Usb(1, 0)
Network/Acpi(PNP0A03,0)/Pci(1E|0)/Pci(8|0)/Mac(000B5D6F80A9)
Boot Option Maintenance Menu
Setup Menu
2
Start EFI Shell.
Select [EFI Shell (Built-in)], and press the [Enter] key.
EFI Shell starts.
3 List drivers.
After EFI Shell starts, enter the following, and press the [Enter] key:
Shell> drivers -b
A list of drivers is displayed as shown below.
Find the line with "Emulex SCSI Pass Thru Driver" displayed in the DRIVER
NAME column, and record its value in the DRV column. In the following
example, 22 is the driver identification number.
D-12
Ctrl[ALL] Lang[eng] - Options set.
http://www.emulex.com/ts/index.jsp
Action Required is None
C122-E001-10EN