Fujitsu PRIMEQUEST 500A Series Installation Manual page 323

2 Restart the service.
[Red Hat Enterprise Linux]
# service ntpd restart
[SUSE Linux Enterprise Server]
# /etc/init.d/xntpd restart
3
Modify the service configuration.
[Red Hat Enterprise Linux]
# chkconfig ntpd on
[SUSE Linux Enterprise Server]
# chkconfig xntpd on
4.11.3.2 Setting NTP in a Windows partition
This section explains how to set a Windows controlled NTP in a partition.
1
Log on to the system with the Administrator account.
2 Click [Control Panel]
The [Date and Time Property] dialog box appears.
3
Click the [Internet Time] tab.
4
Specify the MMB virtual IP address in the [Server:] box, and then click [OK] to
close the box.
5
Click the [Internet Time] tab again from the [Date and Time Property] dialog box,
and then click [Update Now]. During normal communication with the NTP
server, the message shown in
synchronization has been established.
C122-E001-10EN
→
[Date and Time].
Figure 4.60 is displayed to report that
4.11 NTP Client Setup
4-137