Fujitsu PRIMEQUEST 500A Series Installation Manual page 209

Note:
4.3.1 Checking the management LAN settings
This section describes how to check the management LAN settings.
For communication of PSA with the MMB via the management LAN, the NIC
connected to the management LAN must be active.
(1) Checking the settings for the NIC of the management LAN
Execute the following command to check the interface name assigned to the NIC of
the management LAN.
1
Enter the ifconfig command to list the network interfaces recognized by the
system and confirm the relevant interface name.
Command syntax:
/sbin/ifconfig –a
Example: eth0, eth1, and lo displayed on the left side are interface names.
C122-E001-10EN
4.3 PSA Installation (Linux: Red Hat) (PRIMEQUEST 520A/520/420)
- Adding of description to the services file (*2)
*1 These automatic startup settings are disabled because of
conflicts with some PSA functions.
*2 Added Port:
Port numbers are not checked for duplication when contents are
added to the fj-webgate (24450) services file. Change them as
necessary.
If the IP address of the MMB or the IP address of the management LAN has
been changed, be sure to restart the PSA. Otherwise, a display error on the
PSA window of the MMB Web-UI may occur, and errors detected by the
PSA are not reported.
4-23