Mmb Connection And Setup; Connection Environment Settings For Actual Operation - Fujitsu PRIMEQUEST 500A Series Installation Manual

2.2

MMB Connection and Setup

When you start MMB setup, the MMBs are in a test environment constructed by a
certified service engineer, and test programs have been executed in it. Therefore, you
need to reset the MMBs for actual operation.
More specifically, you need to specify MMB IP addresses and connect cables
assuming actual operation. After the MMBs are connected, use the MMB Web-UI
(Web user interface) to register and specify the user accounts, security parameters,
time, and other MMB settings.
The figure below shows the MMB connection and setup flow.
Connection environment settings for
actual operation
Network settings for actual operation
MMB initialization
2.2.1

Connection environment settings for actual operation

The connection environment for testing must be reset for actual operation. You need
to perform the following operations:
Specifying the IP address for the PC to be used as the MMB console
Connecting the MMB console PC to the MMB user port
External LAN connection for PRIMEQUEST (PRIMEQUEST 580A/540A/580/
540/480/440)
→
( 2.2.1.3)
C122-E001-10EN
→
2.2.1
→
2.2.3
→
2.2.4
2.2 MMB Connection and Setup
Set up the connection environment for actual
operation.
Set up the network and Web server to be used
for actual operation.
Registration of user accounts
Setting user account of certified service
engineer
Setting system name
Setting date and time
Setting Telnet
Setting a VLAN in a administration LAN hub
→
( 2.2.1.2)
→
( 2.2.1.1)
2-3