Fujitsu PRIMEQUEST 500A Series Installation Manual page 222

CHAPTER 4 Work Required After Operating System Installation
4.3.10 PSA uninstallation
Using the following commands in the order shown, stop the PSA service, and
uninstall the PSA package.
Command syntax:
/sbin/service y30FJSVpsa stop
/bin/rpm -e FJSVpsa
4.3.11 SIRMS uninstallation
Using the following commands, uninstall the two SIRMS packages.
Command syntax:
/bin/rpm -e sirms
/bin/rpm -e FJSVsoftmsg
Note:
4-36
SIRMS is a function to collect software configuration information when
REMCS is in use. It must be installed at the time of PSA installation.
However, you do not need to install it if you perform batch installation using
the PRIMEQUEST installation support tool or bundled-software package
installer.
C122-E001-10EN