External Lan Connection For Primequest (Primequest 580A/540A/580/540/480/440) - Fujitsu PRIMEQUEST 500A Series Installation Manual

2.2.1.3 External LAN connection for PRIMEQUEST (PRIMEQUEST
580A/540A/580/540/480/440)
This section describes the configuration for and notes on PRIMEQUEST external
LAN connections. Fujitsu recommends establishing the external LAN connection
after making the security settings.
IP =
192.168.3.202
Figure 2.2 Management LAN network configuration and IP addresses
The MMB#0 and MMB#1 management (user) ports are connected to an external
switching hub via LAN cables. At the same time, a general-purpose PC for MMB
Web-UI operation is also connected to the hub.
Specify the same subnet for the physical and virtual IP addresses of MMB#0 and
MMB#1.
Each MMB has a physical IP address (192.168.1.100 for MMB#0 and 192.168.1.101
for MMB#1 in the above figure) and a virtual IP address (192.168.1.102 in the above
figure). The virtual IP address is used for communication with the externally
connected targets (Web browser, maintenance terminal, REMCS, and others).
C122-E001-10EN
IOU#0
BMM#1
BMM#0
IP =
192.168.1.1
MMB#0
IP =
192.168.1.100
For management by the user
For remote
REMOTE REMOTE
maintenance
For local maintenance
Dial-up router or
external switch
Maintenance terminal (FST)
IP =
REMCS center
192.168.1.200
(PRIMEQUEST 580A/540A/580/540/480/440)
IOU#7
IP =
192.168.1.8
VIP =
192.168.1.102
MMB#1
IP =
192.168.1.101
REMCS VIP =
192.168.3.102
For remote REMOTE REMOTE
maintenance
For local maintenance
External switch
Notes:
1. The IP addresses in this figure are examples.
Web-UI Web-UI
2. IP: Physical address
VIP: Virtual IP address
IP =
REMCS IP: IP address for remote maintenance.
192.168.1.201
3. Two subnets must be setup: One for management by
the user and the other for remote maintenance.
Specify the same subnet for management by the user
and for local maintenance.
4. BMM#1 is supported only in the
PRIMEQUEST 580A/540A/580/540.
2.2 MMB Connection and Setup
BMM#1
BMM#0
For management by the user
2-5