Fujitsu PRIMEQUEST 500A Series Installation Manual page 146

CHAPTER 3 Operating System Installation
This section describes the following types of operations:
Preparing for installation
Windows installation using SystemcastWizard Lite
Windows installation using the installation support tool
Windows Installation using the KVM (PRIMEQUEST 580A/540A/580/540/480/
440)
→
( 3.3.4)
Windows Installation using the independent KVM switch
(PRIMEQUEST 520A/520/420)
High-Reliability Tools
Note:
3.3.1 Preparing for installation
This manual describes necessary procedures for the PRIMEQUEST machine. For the
configuration and tuning procedures for SAN storage products and Fibre Channel
switches, see their respective manuals. A Fujitsu certified service engineer sets up the
SAN boot environment. For details, contact your Fujitsu certified service engineer.
3.3.1.1 Setting up a SAN boot environment
The following types of work are required for setting up the SAN boot environment.
For details on the procedure, see
Environment."
Designing the SAN boot environment
The reliability that can be obtained depends greatly on the topologies of the
PRIMEQUEST machine, SAN storage, and FC switches.
Making SAN boot settings for the PRIMEQUEST machine
Set up the SAN storage units and PRIMEQUEST machine according to the
configuration design. The Fibre Channel EFI driver must be configured.
Set up SAN storage and Fibre Channel switches
Mount, connect, configure, and tune the SAN storage units and Fibre Channel
switches according to the connection diagram prepared during environment
design.
3-24
→
(
→
( 3.3.6)
Use SystemcastWizard Lite to install Windows Server 2003, Enterprise
Edition (IA64) purchased with a volume license.
3.3.1)
→
( 3.3.5)
Appendix D, "Installation in the SAN Boot
→
( 3.3.2)
→
( 3.3.3)
C122-E001-10EN