Fujitsu PRIMEQUEST 500A Series Installation Manual page 410

Appendix D Installation in the SAN Boot Environment
14 Scan Targets.
Select [1. Scan Targets], and press the [Enter] key.
A list of data is displayed as shown below:
Here are targets numbers 001 thru 001:
001: DID:0000EF WWN:202C00E0 00CB0815
15 Select the target from the displayed data by using the cursor key, and press the
[Enter] key.
The LUN connected to the target is displayed as shown below:
Here are Luns numbers 0001 thru 0001:
0001: Mode: Peripheral dev LUN: 0000
16 Select the LUN to be used for boot by using the cursor key, and press the [Enter]
key.
001: DID:0000EF WWN:202C00E0 00CB0815 Mode: Per LUN: 0000
17 Select [1. Boot this device via WWN], and press the [Enter] key.
The following list is displayed:
01: DID:000000 WWN:202C00E0 00CB0815 Mode: Per LUN: 0000
02: DID:000000 WWN:00000000 00000000
03: DID:000000 WWN:00000000 00000000
04: DID:000000 WWN:00000000 00000000
05: DID:000000 WWN:00000000 00000000
06: DID:000000 WWN:00000000 00000000
07: DID:000000 WWN:00000000 00000000
08: DID:000000 WWN:00000000 00000000
D-16
Selected Boot Device:
1. Boot this device via WWN.
2. Boot this device via DID.
C122-E001-10EN