Fujitsu PRIMEQUEST 500A Series Installation Manual page 306

CHAPTER 4 Work Required After Operating System Installation
4.9.3.4 Setting the kdump service
Enter the following so that the kdump service automatically starts when the system
boots.
# chkconfig kdump on
Enter the following to check whether the dump service has been set correctly.
# chkconfig -- list kdump
The settings are displayed as shown below:
kdump
4.9.3.5 Setting the kernel parameter
Specify the following with the kernel parameter append in /boot/efi/efi/redhat/
elilo.conf.
append="
4.9.3.6 Rebooting the system
Enter the following to reboot the system.
# reboot
4-120
0:off 1:off 2:on 3:on 4:on 5:on 6:off
· · ·
crashkernel=512M@256M"
C122-E001-10EN