Fujitsu PRIMEQUEST 500A Series Installation Manual page 244

CHAPTER 4 Work Required After Operating System Installation
• If PORT is not specified, the default SNMP trap port (162) is used.
Example: When you want to send traps with the community name "public" to port
trapsink
trap2sink
SNMPv3 trap setting
trapsess SNMPCMD_ARGS HOST[:PORT]
Define the host that receives the traps (to which traps are sent). If PORT is not
specified, the default SNMP trap port (162) is used.
The major options that can be specified for SNMPCMD_ARGS are as follows:
-v version: Specifies the SNMP version. Specify 3 for SNMPv3.
-e engineID: Specifies the value of oldEngineID in the /var/net-snmp/snmpd.conf file
-u secName: Specifies the SNMPv3 account. It must be the same as the setting in the
-l secLevel: Specifies one of the following according to the security level of
-a authProtocol:
4-58
162 of the manager with IP address 192.168.1.10
192.168.1.10
192.168.1.10
in the trap sender.
manager.
SNMPv3 messages:
Table 4.4 secLevel settings
Setting
noAuthNoPriv
authNoPriv
authPriv
Specifies MD5 or SHA as the protocol used to authenticate
SNMPv3 messages. If SHA is to be used, a package must be
created using openssl that is installed. This option is valid when
authentication is included in the security level specified by the -l
option. It can be omitted if authentication is not included.
public 162
public 162
#SNMPv3 trap setting
Authentication
No
Yes
Yes
##SNMPv1 trap setting
##SNMPv2 trap setting
Encryption
No
No
Yes
C122-E001-10EN