Fujitsu PRIMEQUEST 500A Series Installation Manual page 395

Appendix D Installation in the SAN Boot
A
This appendix describes the SAN boot environment setup in Windows.
D.1 Confirmation of Necessary Items
Confirm the necessary items. The following items (hardware and software) are
required for setting up the SAN boot environment.
This section uses Fujitsu's ETERNUS storage product as an example, but the basic
unit settings are the same for other manufacturer's SAN storage units, if they are used.
PRIMEQUEST
Fibre Channel (FC) card
SAN storage unit (ETERNUS)
FC switch (as needed for configuration)
PC used to configure the SAN storage unit (ETERNUS) and FC switch (The PC
can also be used as the MMB console or other such console.)
Windows Server 2003, Enterprise Edition for Itanium-based Systems or Windows
Server 2003, Datacenter Edition for Itanium-based Systems
USB floppy disk drive
(when installing via KVM)
C122-E001-10EN
Environment
D-1