Fujitsu PRIMEQUEST 500A Series Installation Manual page 162

CHAPTER 3 Operating System Installation
7 Install the driver manually.
1
When the following message appears, press the [S] key.
To specify additional SCSI adapters, CD-ROM drivers,
or special disk controllers for use with Windows,
including those for which you have a device support
disk from mass storage device manufacturer, press S
2
When the following message appears, connect the USB floppy disk drive to
the USB port of the KVM interface unit, and insert the driver disk prepared in
Remarks of step 3 into the floppy disk drive.
Please insert disk labeled Manufacture-supplied hard-
ware support disk into Drive A:
3 Press the [Enter] key. The following message appears.
You have chosen to configure a SCSI adapter for use
with Windows, using a device support disk provided by
an adapter manufacturer. Select the SCSI adapter you
want from the following list, or press ESC to return
the previous screen
4
Make the following selection, and press the [Enter] key:
Emulex LPX000 PCI Fibre Channel HBA
Make the following selection for SCSI:
LSI Logic PCI Fusion-MPT Driver (Server 2003 IA64)
Following on-screen instructions, perform the additional work of installing
the FC driver for any mounted FC card in the partition even if its cable is not
connected.
Note: Do not remove the USB floppy disk drive until installation is
8
Continue installation by following the instructions from the setup program.
For details, see the OS manual.
When a message requesting a floppy disk appears during installation, insert the
driver disk, and press the [Enter] key.
Remarks: The setup program requests a product ID during installation. The
3-40
completed.
product ID location varies depending on the installed operating system
and purchase method.
C122-E001-10EN