Fujitsu PRIMEQUEST 500A Series Installation Manual page 148

CHAPTER 3 Operating System Installation
3.3.1.3 Pre-installation notes (PRIMEQUEST 580A/540A/580/540/480/
440)
Note:
Set it by following the procedure below.
1
In the MMB Web-UI window, click [Partition]
[Mode] window is displayed.
Figure 3.14 [Mode] window (PRIMEQUEST 580A/540A)
2
Select [PCI Bus Mode] and click the [Apply] button.
The message box "A Partition power off/on is required in order to make set..." is
displayed, click [OK] to continue processing.
Note:
3-26
Windows does not support PCI Segment Mode. When designing partitions
with the PRIMEQUEST machine, set PCI Bus Mode by using the MMB
Web-UI as described below.
Install Windows when the disk partition is in the appropriate state. If
installation is attempted in overwrite mode when Linux is already installed,
installation fails. Be sure to initialize the disk before installing Windows in
such an environment. For details on SAN disk initialization, see the
manual supplied with the SAN storage unit.
→ →
[Partition#x] [Mode]. The
C122-E001-10EN