Fujitsu PRIMEQUEST 500A Series Installation Manual page 202

CHAPTER 4 Work Required After Operating System Installation
-A authPassword: Specifies an authentication password (eight or more characters).
-x privProtocol:
-X privPassword: Specifies an encryption password (eight or more characters). The
Example: When you want to send SNMPv3 traps with the "PRIMEQUEST" account,
#trapsess –v 3 -e 0x800007e58026577a9f421950a4 -u PRIMEQUEST -l authPriv
-a MD5 -A 00000000
-x DES -X 11111111 192.168.0.162:162
After setting the trap transfer destination, restart snmpd by executing the following
command:
#/etc/rc.d/init.d/snmpd restart
After snmpd has been reactivated, activate PSA.
#/sbin/service y30FJSVpsa stop
#/sbin/service y30FJSVpsa start
4-16
The password must be the same as the setting in the manager.
This option is valid when authentication is included in the security
level specified by the -l option. It can be omitted if the
authentication is not included.
Specifies the protocol used to encrypt SNMPv3 messages.
Currently, only DES is supported as a privacy protocol. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
password must be the same as the setting in the manager. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
with authentication and encryption enabled, to port 162 of the manager
with IP address 192.168.0.162
##SNMPv3 trap setting
C122-E001-10EN