Fujitsu PRIMEQUEST 500A Series Installation Manual page 252

CHAPTER 4 Work Required After Operating System Installation
4.5 PSA Installation (Windows Server 2003)
(PRIMEQUEST 580A/540A/580/540/480/440)
This section describes procedure for installing PSA.
Required tasks:
Checking the management LAN settings
Optional tasks:
Setting the destination of trap sending from the partition
Setting the destinations of trap and e-mail sending via the MMB
Windows firewall setting
Setting Watchdog monitoring after a STOP error (a fatal system error) occurs
(→ 4.5.5)
Remarks:
2
Environment variable setting
3
Port setting
4-66
(→ 4.5.4)
Use the PRIMEQUEST Software Installer or SystemcastWizard Lite to
install PSA. If you want to manually install the PSA, see Chapter 4,
"Manual PSA Installation" in the PRIMEQUEST 500A/500/400 Series
Reference Manual: Tools/Operation Information (C122-E074EN).
For details on installation using the PRIMEQUEST Software Installer, see
Section 3.3.6.1, "Installation using the PRIMEQUEST Software
Installer."
For details on installation using SystemcastWizard Lite, see the
PRIMEQUEST SystemcastWizard Lite User's Guide (C122-E010EN).
When PSA is installed, the following setup tasks are automatically
performed for PSA operation:
1 Service setting
• PRIMEQUEST Server Agent
• PRIMEQUEST PEM Command Service
• PRIMEQUEST PSA Environment Control Service
• PATH variable
Value for use by PSA is added to the existing PATH variable.
• FJSVpsa_INSTALLPATH variable
This is a new variable added.
The parameter is set to ensure that PSA uses the TCP:24450 port.
(→ 4.5.1)
(→ 4.5.2)
(→ 4.5.3)
C122-E001-10EN