Fujitsu PRIMEQUEST 500A Series Installation Manual page 411

18 Press the [Esc] key five times. The system returns to the state at EFI shell startup.
Drv[22]
None
Shell>
19 Apply the settings.
Reset the partition. From the [Power Control] window, select the [Reset] from
[Power Control] pull-down menu of the partition to be reset, and click the [Apply]
button. Otherwise, enter the reset command.
Shell> reset
Remarks: For details, see Emulex Corporation's EFIBoot Web site.
D.4.5 Notes on replacing an FC card
When an FC card to which the boot device is connected is replaced, use the procedure
described in
the replaced FC card.
Also, make the required settings of the FC card according to the manuals for the FC
switch and the storage devices to be connected.
Change of zone setting for FC switch (when making the WWN zone setting)
Change of ETERNUS Host-Affinity setting
Change of EFI driver setting
C122-E001-10EN
Ctrl[ALL] Lang[eng] - Options set.
http://www.emulex.com/ts/downloads/index.jsp
Appendix D.4.4, "Configuring the EFI driver,"
D.4 Settings
Action Required is None
to set the boot device for
D-17