Fujitsu PRIMEQUEST 500A Series Installation Manual page 254

CHAPTER 4 Work Required After Operating System Installation
Notes:
4-68
In the first attempt to open the PSA window from the Web-UI after the
system restart following PSA installation, the error message "E_33077
PSA is Not Active. (01:0000)" may be displayed. This may occur
because PSA requires a certain amount of time to acquire sensor
information for the system. Wait a few minutes, then try to open the
window again.
After changing the IP address of an MMB or management LAN on the
partition side, be sure to restart PSA. Otherwise, a PSA screen display
error occurs in the Web-UI and detectable errors in PSA cannot be
reported.
For PSA setup in Windows, the following points must be noted:
- Do not enable Visual Notification in the Dr. Watson options.
Otherwise, if a PSA error occurs and a message box opens, PSA cannot
be restarted until the message box is closed.
- Do In the properties for the system log of the event viewer of the
application log, do not change the operation that is performed when the
maximum log size is reached to "Do not overwrite events (clear log
manually). Otherwise, any error that occurs when the maximum log
size is reached is not output to the log.
- Do not stop the Windows service, print spooler service.
The operating system information collection function uses the
Windows Management Instrumentation (WMI) to collect the
configuration information. However, when the print spooler service is
stopped, an error is reported to WMI and configuration information is
not collected correctly.
- If the following registry is set to under 20000 (this means 20 seconds),
Windows OS may become hung-up at OS Shutdown. Therefore, be
sure to set more than 20000 (this means 20 seconds). (Default value:
20000)
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet
\Control\WaitToKillServiceTimeout
(This registry determines how long the system waits after OS
shutdown before stopping services.)
- The following message may be displayed when PSA starts up, but this
dose not cause any problems.
"PM child process abnormal end [6:750] (tagt) 1:0x00000000"
FJSVpsa Event ID 62
C122-E001-10EN