Table of Contents
Advertisement
4.6.5
Setting Watchdog monitoring after a STOP error (a fatal system
error) occurs
If a STOP error (a fatal system error) occurs in the system, the results are as follows:
PRIMEQUEST 520A/520/420
• "Panic" is displayed for "System Progress" of the relevant partition in [Partition]-
[Power Control] of the MMB Web-UI.
• A memory dump is collected in the system.
In such cases, to prevent the system from freezing or otherwise becoming non-
responsive, monitoring using the Watchdog timer can be set.
When the specified time has elapsed, the MMB executes a Hard Reset, and the OS is
rebooted.
Setting procedure
1
Open the following file:
[PSA installation folder] \etc\opt\FJSVpsa\usr\pnwatchdog.conf
(Example: C:\Program Files\fujitsu\FJSVpsa\etc\opt\FJSVpsa\usr
2
Specify a key value as shown below. The default is 0.
Section: [WATCHDOG]
Key: [TIMER]
Set value (unit: seconds) 0 (Watchdog timer not used)
Remarks: For the set value, measure the time required for memory dump in the
C122-E001-10EN
4.6 PSA Installation (Windows Server 2003) (PRIMEQUEST 520A/520/420)
\pnwatchdog.conf)
1 to 6000 (Watchdog timer monitoring time)
environment to be applied and determine the appropriate value. If the
required time exceeds 6000 seconds (one hour and 40 minutes),
specify 0 (Watchdog timer not used).
If the set value is shorter than the time required for memory dump
processing, the Watchdog timer expires, resulting in execution of a
Hard Reset, with the result that the memory dump cannot be collected
correctly.
4-93
Advertisement
Chapters
Table of Contents
