Table of Contents
Advertisement
CHAPTER 4 Work Required After Operating System Installation
2
Keep the values set if the message shown below does not appear.
If the message shown below appears, set the displayed value as the minimum
value (200 MB in this example).
Generally, it is recommended to use the value that is automatically assigned
by the operating system.
8
Enter a value in [Maximum size].
Specify a value greater than [Initial size].
9
Save the settings.
Click [Set] in [Paging file size for selected drive]. The settings are saved and
displayed under [Paging File Size] of [Drive].
10 Click [OK] to close the [Virtual Memory] dialog box.
11 Click [OK] to close the [Performance Options] dialog box.
12 Click [OK] to close the [System Property] dialog box.
13 Reboot the system.
The settings are validated after the system reboot.
4.10.1.5 Note
Note that if the paging file is allocated to a partition other than the system partition
(usually drive C), no dump file is generated when a stop error occurs. Unless
otherwise instructed, do not move the paging file.
4-130
Figure 4.56 Confirmation message window
C122-E001-10EN
Advertisement
Chapters
Table of Contents
