Fujitsu PRIMEQUEST 500A Series Installation Manual page 217

-x privProtocol: Specifies the protocol used to encrypt SNMPv3 messages.
-X privPassword: Specifies an encryption password (eight or more characters). The
Example: When you want to send SNMPv3 traps with the "PRIMEQUEST" account,
trapsess –v 3 -e 0x800007e58026577a9f421950a4 -u PRIMEQUEST -l authPriv -a
MD5 -A 00000000
-x DES -X 11111111 192.168.0.162:162
After setting the trap transfer destination, restart snmpd by executing the following
command:
#/etc/rc.d/init.d/snmpd restart
After restart of snmpd is completed, restart PSA.
#/sbin/service y30FJSVpsa stop
#/sbin/service y30FJSVpsa start
C122-E001-10EN
4.3 PSA Installation (Linux: Red Hat) (PRIMEQUEST 520A/520/420)
Currently, only DES is supported as a privacy protocol. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
password must be the same as the setting in the manager. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
with authentication and encryption enabled, to port 162 of the manager
with IP address 192.168.0.162
##SNMPv3 trap setting
4-31