Fujitsu PRIMEQUEST 500A Series Installation Manual page 89

2.5 Partition Initialization
This section describes the procedures used to specify a variety of partition
information. If multiple partitions exist, perform the setup procedures for each
partition.
This section explains the following.
Partition setting flow
Shutting down a partition
Splitting and merging SBs, IO Units, and IOXs (in the PRIMEQUEST 500A/500
series only)
Adding an SB, IO Unit, and IOX
Removing an SB, IO Unit, or IOX
Setting a Home IOU
Setting a reserved SB
Setting partition names
Setting various modes
Starting a partition
Checking partition information
2.5.1 Partition setting flow
When creating partitions, follow the workflow in the chart shown below as many
times as the number of created partitions. The procedures described below show
sample screenshots of windows displayed for the PRIMEQUEST 580A/540A/580/
540/480/440.
Note:
C122-E001-10EN
→
( 2.5.1)
→
(
→
( 2.5.3)
→
( 2.5.5)
→
( 2.5.6)
→
( 2.5.7)
→
( 2.5.8)
→
( 2.5.9)
After changing the configuration of a partition that is active, be sure to
shut down and reboot it.
2.5.2)
→
( 2.5.4.1)
→
( 2.5.4.2)
→
( 2.5.10)
2.5 Partition Initialization
2-43