Fujitsu PRIMEQUEST 500A Series Installation Manual page 330

CHAPTER 4 Work Required After Operating System Installation
(1) Switch to single-user mode
To perform the backup, the user must deactivate all processes except those required to
perform it. This is to secure file matching.
To enter this state, switch to single-user mode.
When the system is already active
1
Log in with the root directory.
2
Stop running applications.
3 Enter single-user mode (run level 1).
# init 1
When the system is in a stopped state
1
Start the system.
When the EFI boot manager menu appears, select the name of the system to
be started (such as Red Hat Enterprise Linux).
Note:
2
Enter the command shown below following the "ELILO boot:" prompt.
• When a KVM console is used
kernel-label-name 1
• When a serial console is used
kernel-label-name 1 console=ttyS0,19200n8r
After completing the transition to the single user mode, a prompt appears in
command line mode.
Note:
4-144
Advance settings are required to start the EFI boot manager menu.
For the setting procedure, see Section 5.3.8.2, "[Boot Control]
window" in the PRIMEQUEST 580A/540A/520A/500/400 Series
Reference Manual: Basic Operation/GUI/Commands (C122-
E003EN).
To check the current kernel-label-name, see the default entry
in the following config file:
/boot/efi/efi/redhat/elilo.conf
C122-E001-10EN