Fujitsu PRIMEQUEST 500A Series Installation Manual page 147

3.3.1.2 Connecting a SAN storage unit
To install the operating system on SAN storage, a SAN storage unit must be prepared
as described in
assume that all devices as follows are connected:
In addition, to install Windows on SAN storage, the conditions stated below must be
satisfied. After installation, confirm that Windows can start up and configure it for
the operating configuration.
• Only the LUNs on which Windows is installed can be identified from the
PRIMEQUEST-series machine.
• The PRIMEQUEST-series machine is connected through a single path to the SAN
storage.
Installing Windows on SAN storage by using SystemcastWizard Lite
• Deployment server
• Console (keyboard, display, mouse)
• External RAID (e.g., ETERNUS)
• Fibre Channel card
• Optical fiber cable
• LAN cable
Installing Windows on SAN storage by using the KVM
• Console (keyboard, display, mouse)
• External RAID (e.g., ETERNUS)
• Fibre Channel card
• Optical fiber cable
• Floppy disk drive (must be prepared separately)
In addition, the conditions listed below must be satisfied in order to install Windows
on SAN storage. When installation is completed, confirm that Windows has started
normally, and reconfigure the operating configuration.
• The PRIMEQUEST machine can recognize only the LUN that is the Windows
installation destination.
• The PRIMEQUEST machine and SAN storage are connected by a single path.
C122-E001-10EN
Section 3.3.1.1. The installation procedures in
3.3 Windows Installation
Section 3.3.2 and 3.3.4
3-25