Fujitsu PRIMEQUEST 500A Series Installation Manual page 200

CHAPTER 4 Work Required After Operating System Installation
4.2.4 Installing FJSVfefpcl
Remarks: FJSVfefpcl is supported only in Japan.
4.2.5 Setting the destination of trap sending from the partition
Notes:
When sending SNMP traps from the partition, you must set the trap send destination
on the partition. Add the trap send destination to the snmpd.conf file.
Editing snmpd.conf
# vi /etc/snmp/snmpd.conf
Add the following lines for the SNMP version to be used. The lines can be provided in any order.
trapsink HOST [COMMUNITY [PORT]]
trap2sink HOST [COMMUNITY [PORT]] # SNMPv2 trap setting
trapsess SNMPCMD_ARGS HOST[:PORT] # SNMPv3 trap setting
The settings are detailed below:
Setting SNMPv1/SNMPv2 traps
trapsink HOST [COMMUNITY [PORT]]
trap2sink HOST [COMMUNITY [PORT]] # SNMPv2 trap setting
Define the host that receives the traps (to which traps are sent).
• With this setting made, a cold start trap is sent when snmpd is started. If SNMP
trap sending from the partition is defined, a trap is also sent when authentication
fails.
• Multiple destinations can be defined by specifying multiple pairs of the trapsink
and trap2sink lines.
• If COMMUNITY is not specified, the character string previously specified by the
trapcommunity directive is used.
The trapcommunity command sets the default community string used to send
traps. When using trapcommunity to set the community string, specify the string
before the pair of trapsink-trap2sink lines.
trapcommunity STRING
4-14
Make this setting only if required.
The setting is required if partitions are managed with operation
management software.
# SNMPv1 trap setting
# SNMPv1 trap setting
#COMMUNITY name setting
C122-E001-10EN