Fujitsu PRIMEQUEST 500A Series Installation Manual page 191

# /sbin/ifconfig –a
eth0
eth1
lo
2 Use the ethtool command to find two network interface controllers (NIC) for the
management LAN. Enter the command for each interface displayed in step 1 as
shown below.
The NICs for the management LAN have bus-info (SEG:BUS:DEV.FUNC
number) 0000:01:08.0 and 0000:01:00.0.
Command syntax:
/sbin/ethtool –i <interface-name>
Example: As the result of command execution for eth0 and eth1, these two
# /sbin/ethtool -i eth0
driver: e100
version: 3.0.27-k2-NAPI
firmware-version: N/A
bus-info: 0000:01:00.0 (Matches a NIC for the management LAN)
# /sbin/ethtool -i eth1
driver: e100
version: 3.0.27-k2-NAPI
firmware-version: N/A
bus-info: 0000:01:08.0(Matches a NIC for the management LAN)
C122-E001-10EN
4.2 PSA Installation (Linux: Red Hat) (PRIMEQUEST 580A/540A/580/540/480/440)
Link encap:Ethernet
inet addr:10.24.17.149
inet6 addr: fe80::2d0:b7ff:fe53:89c3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:1107704 errors:0 dropped:0 overruns:0 frame:0
TX packets:2653820 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:390009908 (371.9 MiB)
Link encap:Ethernet
inet addr:192.168.0.162
inet6 addr: fe80::20e:cff:fe21:8397/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:1538726 errors:0 dropped:0 overruns:0 frame:0
TX packets:356 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:341051195 (325.2 MiB)
Base address:0x5cc0 Memory:fbfe0000-fc000000
Link encap:Local Loopback
inet addr:127.0.0.1
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING
RX packets:3865 errors:0 dropped:0 overruns:0 frame:0
interfaces match the NICs for the management LAN.
HWaddr 00:D0:B7:53:89:C3
Bcast:10.24.17.255
MTU:1500
TX bytes:809006934 (771.5 MiB)
HWaddr 00:0E:0C:21:83:97
Bcast:10.24.17.255
MTU:1500
TX bytes:22862 (22.3 KiB)
Mask:255.0.0.0
MTU:16436 Metric:1
Mask:255.255.255.0
Metric:1
Mask:255.255.255.0
Metric:1
4-5