Fujitsu PRIMEQUEST 500A Series Installation Manual page 303

2 Confirm that dump processing is completed.
Confirm that the following message is displayed on the console.
or
3
Reboot the system.
If it has been specified that the system automatically reboot, wait until the
system automatically reboots. If it has been specified that the system halt,
reset and reboot the system. To reset the system, click [Partition]
Control] on the MMB Web-UI, specify [Reset] as the status, and click the
[Apply] button.
4
Confirm that a dump has been collected.
Perform the following two procedures:
• Confirm that a directory of /var/crash/127.0.0.1-[date and time] has been
created.
• To check whether a dump has been collected, check whether a vmcore file
has been created under the above directory.
5
Use the rm command to delete the collected test dump in the above directory.
C122-E001-10EN
Rebooting in nn seconds.
(nn indicates the time in seconds that elapses before a restart.)
halt
4.9 Dump Environment Setup (Linux: Red Hat)
→
[Power
4-117