Fujitsu PRIMEQUEST 500A Series Installation Manual page 112

CHAPTER 2 Setup
2.5.8 Setting various modes
This function sets the PCI address mode (only for PRIMEQUEST 580A/540A/580/
540/480/440) for a partition, the System Mirror Mode, and the Hyper Threading
Mode (only for PRIMEQUEST 500A/500 series).
Note the following about setting XPAR mode:
Notes:
• Extended Mirror Mode cannot be set in partitions containing SBs, IO Units or
IOXs split with XPAR set. No split SB, IO Unit, or IOX can be assigned to a
partition that is set in Extended Mirror Mode.
• No SB split with XPAR set can be assigned as the reserved SB of a partition that
is set in Extended Mirror Mode. Extended Mirror Mode cannot be set in
partitions to which split SBs are assigned as reserved SBs.
• XPAR is supported only in the PRIMEQUEST 500A/500 series, and the XPAR
option is required for setting XPAR.
Procedure
1
Click [Partition]
The [Mode] window is displayed.
Figure 2.44 [Mode] window (PRIMEQUEST 580A/540A)
2-66
→ →
[Partition#x] [Mode].
C122-E001-10EN