Setting Cutting Width (Expand) - GRAPHTEC CE6000-120AP User Manual

Setting Cutting Width (EXPAND)

Set the cutting width. It is possible to set that it will cut to the area outside of the push rollers, or not to cut at the
ends of the media.
Default setting is to the internal edge of the push rollers. It can be set up to 10 mm* outside (positive value) or 10
mm inside (negative value) from the default position. The width will enlarge if the value is set to positive, and the
width will decrease if the value is set to negative. Setting will affect both ends, resulting the total width change
will be double the set value.
* The value of the left-hand margin when using the left grit roller are as follows;
When the left grid roller is used, it does not spread to positive towards the left-hand.
Even if the value between +1 and +10 is set, the left-hand margin will be 0.
Media size
1201 mm to 1220 mm
CAUTION
Do not set the "INITIAL BLADE CONTROL POSITION" of the tool setting to "OUTSIDE" when the setting value is set to more than 8
mm. The blade might be damaged by moving the carriage outside the media under this condition.
Supplement
If the value is set to positive, it is able to cut over where the push rollers are, but the push rollers passes where it is cut, creating a
chance of bad feeding depending on the media.
Set the width of cutting area, and then send the cutting data to the plotter. Cutting data in the buffer memory will be cleared when
cutting area width is changed.
Operation
1
Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/1) is displayed.
3
Press the [1] key (EXPAND).
SET EXPAND LIMIT setting screen is displayed.
Making an expand setting
0 (Default)
Left-hand Right-hand
0 0
+10 mm
Left-hand
0
Supplement
Perform the settings in Normal menu.
See "How to Use Control Panel"
for READY status.
4-4
Right-hand
10 mm
P.2-21