FX-1/FX-1R Maintenance Manual
4-5. Adjusting the Focus
<Procedure>
Place the camera adjustment jig on the top surface of the calibration block, facing its etching
surface down.
Loosen the hexagon socket head cap bolts
camera, move the camera up and down, and when lines up to 2 on the etching surface are
clearly visible (see the figure below), secure the camera in position.
The lines around "2"
「2」まわりの線がはっきり
shall be seen clearly.
見えること。
and
Hexagon socket
head cap bolts (× 4)
SEMS cap
×
bolts
(
2)
カメラアジャスト治具
Camera adjustment jig
E2106998000
E2106998000 (T110)
(T110)
4-5
(total of 6 locations) that secure the
Calibration
block
Rev. 2.00