Table of Contents
Advertisement
(2) Adjusting the seam allowance
1 In the case of sewing garment bodies of men's wear (set Men's/Ladies' mode selective switch ! 0
mounted on the right-hand side of the operation panel to its lower side.) (See p.4.)
B
A
™Adjusting distance A
1
3
Loosen screws 1 in setting plates,right 2 and left 3. Shift the respective setting plates to the desired
values and tighten the screws.
™Adjusting distance B
Loosen thumbscrew 1, and shift gauge 2 to the right or left until desired scale value 3 is reached.
Then tighten the thumbscrew.
1
1
2
3
6
−
1) Adjust the seam allowance from the side end of
the garment to the button (distance A in the figure),
and from the top end of the garment to the 1st button
(distance B in the figure.)
(Caution) Be sure to make adjustment of the seam
allowance after you have turned OFF the
power switch.
2) The number of buttons and the intervals between
the buttons can be adjusted using the panel
switches. (Refer to "Inputting the sewing data" on
page 28.)
1
2
As viewed from above the unit
As viewed from above the unit
−
1
Advertisement
Table of Contents
