Relevant Error Codes; E602 And Detailed Codes; Points To Note In Initialization Via Sst; Points To Note In Initialization Using Usb - Canon imageRUNNER ADVANCE 8105 Series Service Manual

2
Technology > Main Controller > Controls > HDD Encryption/ Mirroring Kit (optional)
*1: How to Initialize Encryption Board
1. Initialize the encryption board via SST.
This step makes the disk unformatted (E602-0001 is triggered if the unformatted disk is
started).
2. Format the HDD and reinstall SYSTEM via SST.
When you start the HDD formatting, the message is automatically shown to confirm whether
to initialize the encryption board (Key Clear).
Key Clear will disable accesses to HDD data permanently. Cautions should be taken in Key
Clear execution.
<Points to Note in Initialization via SST>
The screen below is shown when you gain access to SST in safe mode due to E602-2000.
Poor board connection also causes this error. Check the board connection to seek error
recovery. Initialization of the encryption board will disable accesses to HDD data permanently.
Cautions should be taken in initialization.
<Points to Note in Initialization using USB>
The screen below is shown on the control panel when E602-2000 occurred and the machine
is started in safe mode using the USB flash memory with system data stored.
The message as shown in the figure below is displayed.
Select "0" when you are ready to initialize the encryption board.
Encryption board
error occurred.
Check connection
of the board.
Initialize
the board.
All data is deleted
at initialization.
[0]=Initialization
[other key]=exit
2 Technology > Main Controller > Controls > HDD Encryption/ Mirroring Kit (optional)
F-2-39 F-2-39
F-2-40 F-2-40
The figure below shows the final screen in initializing the encryption board.
The message as shown in the figure below is shown on the screen.
Select "2" when you initialize the encryption board.
We recommend checking the board connection before starting initialization
Attention!
Once initialization
is started,you
cannot cancel it.
is that OK?
[2]= Yes
[other keys]=No
●

Relevant Error Codes

E602 and detailed codes

E code Description Cause
E602 Authentication Error Error in authentication
between the host
-2000
machine and the
encryption board
Failure in Encryption Error in recognition of
Board the encryption board
Device Error Failure in the
encryption board
2-29
F-2-41 F-2-41
Detection
Actions
Timing
Check connections between
Start-up
the encryption board and
the HDD and between the
encryption board and the main
controller 2. This error may be
triggered after replacement
of the encryption board or the
main controller 2. At any rate,
this error disables accesses to
HDD data. When no problem
is found in connections, use
SST to execute Key Clear >
Format > Install System.
T-2-17 T-2-17
2-29