Main Controller Pcb - Canon imageRUNNER ADVANCE 8105 Series Service Manual

2
Technology > Main Controller > Service Operations > Main Controller PCB 1
When using the Card Reader and imageWARE Accounting Manager
Card ID used for imageWARE Accounting Manager is stored in the HDD, so NSA
collection control is not enabledafter the HDD replacement. After the HDD is replaced,
reinstall the card ID from imageWARE Accounting Manager using the following
procedures.
1) Go to COPIER > FUNCTION> INSTALL > CARD and enter the numerical value of
the leading card which is used for Department ID. Then, press "OK" button.(e.g.: If
No.1 to No.1000 cards are used for Department ID, enter "1" of the leading card.)
2) After turning OFF and ON the main power switch, perform the following operations
from Settings/Registration mode.
In Management Settings > User Management > Department ID Management > Page
Totals, be sure that "ID00000001" to "ID00001000" are created.
Set the following: Preferences > Network > TCP / IP Settings > IPv4 Settings> IP
Address Settings > IP Address, Gateway Address, Subnet Mask
In Management Settings > User Management> System Manager Information
Settings> System Manager ID and System PIN, register any number for them. Then,
turn OFF and ON the main power switch.
If "System Manager ID" and "System PIN" are not registered, "card registration
to device" cannot be executed for the imageWARE Accounting Manager setting
operation.
3) Download the card ID from imageWARE Accounting Manager to the Main Body
again.
4) After downloading is completed, go to Management Settings > User Management >
Department ID Management > Page Totals. Be sure that only the downloaded card
ID is displayed.
5) Print using the user card registered from imageWARE Accounting Manager. Be sure
that the card information used for the target devices of imageWARE Accounting
Manager is collected.
Note: Points to Note when Using the System Software-installed HDD
When using the HDD which was installed the system software of the other achine
(different serial number), be sure to format the HDD after the installation. If the HDD is
not formatted, the operation cannot be guaranteed.
2 Technology > Main Controller > Service Operations > Main Controller PCB 1
■

Main Controller PCB 1

<Procedure of parts replacement>
see "Removing Main Controller PCB 1," on p. 4-80.
<Procedure of adjustment>
Service part:
Setting unit: Main Controller PCB 1 + Controller Box Frame + Cooling Fan
Parts number differs on a model basis (speed basis).
Cooling Fan
Controller
BOX Frame
In order to secure the accuracy of connector connection when slotting in, this service part is
provided with the
PCB being installed to the frame.
1) Transferring the parts from old PCB to new PCB
•
DDR2-SDRAM (2 pc.)
• Flash PCB
•
TPM PCB
TPM PCB
2-32
Main Controller PCB 1
F-2-42 F-2-42
DDR2-SDRAM
Flash PCB
F-2-43 F-2-43
2-32