G. Primary Charging Assembly
1. Removing the Primary Charging Assembly
1) Open the front door, and open the hopper assembly.
2) Loosen the mounting screw
3) Disconnect the connector
Note:
After servicing the charging assembly, execute cleaning of the wire in user mode.
(If the surface temperature of the upper fixing roller is 100°C or less, you need not
perform this step, as the execution will be automatic.)
H. Pre-Transfer Charging Assembly
1. Removing the Pre-Transfer Charging Assembly
1) Open the front assembly, and slide out the hopper assembly.
2) Remove the mounting screw
pre-transfer charging assembly
Note:
After servicing the charging assembly, execute cleaning of the wire in user mode.
(If the surface temperature of the upper fixing roller is 100°C or less, you need not
perform this step, as the execution will be automatic.)
COPYRIGHT © 1997 CANON INC.
, and slide up the fixing member
, and remove the primary charging assembly
Figure 4-315
, and disconnect the connector
.
Figure 4-316
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
to fix it in place.
; then, remove the
.
4-45