H. Pre-Transfer Charging Assembly
1. Removing the Pre-Transfer Charging Assembly
1) Open the front door, and slide out the hopper assembly.
2) Remove the mounting screw
pre-transfer charging assembly
Caution:
After installing the pre-transfer charging assembly, execute 'wire cleaning' in user
mode. (You need not perform this step if the surface temperature of the upper fixing
roller is 100°C or less, since wire cleaning will be executed automatically.)
I. Transfer/Separation Charging Assembly
1. Removing the Transfer/Separation Charging Assembly
1) Open the front door, and slide out the fixing/feeding unit.
2) Remove the fixing/feeding front cover.
3) Remove the mounting screw
COPYRIGHT © 1997 CANON INC.
, and disconnect the connector
.
Figure 4-316
, and remove the fixing guide
Figure 4-317
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
; then, remove the
.
4-49